Copyright: Created with EasyHelp (Tel: 0973 209667)


Analog/Analog Output - RG354272

Description

This function block exists only in an L5201 Analog I/O Module.  It controls the L5201's analog voltage and current output terminals.  Only one of the two outputs can be active at any time.

The output Setpoint is an input to the function block.  The block is enabled or disabled by the Status input.  IF the L5201's outputs are unused, the block can be disabled to free-up processing time for other tasks.  If enabled, the Setpoint is sampled at 330 Hz (3ms sample period).  The result is then put through a low-pass filter and sent to either the voltage or current controller, based on the configured value of Output type.

Parameters

Get Setpoint	Returns the output setpoint value.  The value is returned as a percentage of the full-scale setpoint.

Get Status	Returns the Status of the block, either Enabled or Disabled.

Set Setpoint	Specifies a value for the output Setpoint, which is the input to this block.  Expects a value in the range 0% to 100%.

Set Status	Specifies the Status of the block, either Enable or Disable.


Description

This function block exists only in an L5201 Analog I/O Module.  It controls the L5201's analog voltage and current output terminals.  Only one of the two outputs can be active at any time.

The output Setpoint is an input to the function block.  The block is enabled or disabled by the Status input.  IF the L5201's outputs are unused, the block can be disabled to free-up processing time for other tasks.  If enabled, the Setpoint is sampled at 330 Hz (3ms sample period).  The result is then put through a low-pass filter and sent to either the voltage or current controller, based on the configured value of Output type.


Parameters

Get Setpoint	Returns the output setpoint value.  The value is returned as a percentage of the full-scale setpoint.

Get Status	Returns the Status of the block, either Enabled or Disabled.

Set Setpoint	Specifies a value for the output Setpoint, which is the input to this block.  Expects a value in the range 0% to 100%.

Set Status	Specifies the Status of the block, either Enable or Disable.